TP-Link JetStream T3700G-52TQ - Show Interface Switchport; Show Vlan Summary

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Specify the PVID of Gigabit Ethernet port 1/0/3 (Trunk) as 1:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)#switchport trunk native vlan 1
4.10 show interface switchport
Description
The show interface switchport command is used to display the information
of one or all Ethernet ports.
Syntax
show interface switchport [ fastEthernet port | gigabitEthernet port |
ten-gigabitEthernet
port | port-channel lagid ]
Parameter
port ——The Fast/Gigabit/Ten-Gigabit Ethernet port number.
lagid ——The ID of the LAG.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the detailed information of Gigabit Ethernet port 1/0/3:
T3700G-52TQ(config)#show interface switchport gigabitEthernet 1/0/3
4.11 show vlan summary
Description
The show vlan summary command is used to display the summarized
information of IEEE 802.1Q VLAN.
36