TP-Link JetStream T3700G-52TQ - Ip Pim Bsr-Candidate Interface

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
default —— Enable PIM SSM in the default multicast groups: 232.0.0.0
255.0.0.0..
group-address —— Enable PIM SSM in the specified multicast group.
group-mask —— Enable PIM SSM in the specified multicast group with this
mask.
Command Mode
Global Configuration Mode
Example
Enable PIM SSM function in the default multicast group:
T3700G-52TQ(config)# ip pim ssm default
42.5 ip pim bsr-candidate interface
Description
The ip pim bsr-candidate interface command is used to configure the
candidate BSR on specified interface. To disable the candidate BSR, please
use no ip pim bsr-candidate command.
Syntax
ip pim bsr-candidate interface { { fastEthernet | gigabitEthernet |
ten-gigabitEthernet }
port | vlan vlan-id } [ hash-mask-length ] [ priority ]
[
interval ]
no ip pim bsr-candidate
Parameter
fastEthernet | gigabitEthernet | ten-gigabitEthernet —— The port type of the
interface.
port —— The port number.
vlan-id —— The interface VLAN ID.
hash-mask-length —— Hash function mask length, ranging from 0 to 32.
priority —— The priority of the BSR, ranging from 0 to 255.
interval ——The BSR Advertisement interval, ranging from 1 to 16383
seconds.
368