TP-Link JetStream T3700G-52TQ - Chapter 22 System Configuration Commands; System-Time Manual; System-Time Ntp

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 22 System Configuration Commands
System Configuration Commands can be used to configure the system information and system
IP of the switch, and to reboot and reset the switch, upgrade the switch system and commands
used for device diagnose.
22.1 system-time manual
Description
The system-time manual command is used to configure the system time
manually.
Syntax
system-time manual time
Parameter
time —— Set the date and time manually, in the format of MM/DD/YYYY-
HH:MM:SS.
Command Mode
Global Configuration Mode
Example
Configure the system time as 02/14/2012-12:30:00:
T3700G-52TQ(config)#system-time manual 02/14/2012-12:30:00
22.2 system-time ntp
Description
The system-time ntp command is used to configure the time zone and the IP
address for the NTP Server. The switch will get UTC automatically if it has
connected to an NTP Server.
Syntax
system-time ntp { timezone } { ntp-server } { backup-ntp-server }
138