JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
12.5 user access-control port-based
Description
The user access-control port-based command is used to limit the ports for
login. Only the users connected to these ports you set here are allowed to
login. To cancel the user access limit, please use no user access-control
command.
Syntax
user access-control port-based interface { gigabitEthernet
port-list
} [ snmp ]
[ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ]
no user access-control
Parameter
port-list
——The list group of Ethernet ports, in the format of 1/0/1-4. You can
appoint 5 ports at most.
[ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ] —— Specify the access
interface. These interfaces are enabled by default.
Command Mode
Global Configuration Mode
Example
Configure that only the users connected to ports 2-6 are allowed to login:
T3700G-52TQ(config)# user access-control port-based interface
gigabitEthernet 1/0/2-6
12.6 media-type rj45
Description
The media-type rj45 command is used to configure the console media type
as RJ-45 for input. The switch has two console ports available —— an RJ-45
console port and a micro-USB console port. Console input is active on only
one console port at a time. By default, the micro-USB connector takes
precedence over the RJ-45 connector, which means that, when both the
RJ-45 console connection and micro-USB console connection are valid,
input from the RJ-45 console is disabled, and input from the micro-USB
71
To Next Page
Loading...
