TP-Link JetStream T3700G-52TQ - Ip Igmp Snooping Mtime; Ip Igmp Snooping Mtime(Interface)

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
31.6 ip igmp snooping mtime
Description
The ip igmp snooping mtime command is used to specify member port
aging time globally. The default aging time is 260 seconds. To restore the
default timer, please use no ip igmp snooping mtime command.
Syntax
ip igmp snooping mtime mtime
no ip igmp snooping mtime
Parameter
mtime —— Specify the aging time in seconds, ranging from 2 to 3600. The
default aging time is 260 seconds.
Command Mode
Global Configuration Mode
Example
Specify IGMP Snooping member port aging time as 100 seconds globally:
T3700G-52TQ(config)# ip igmp snooping mtime 100
31.7 ip igmp snooping mtime(interface)
Description
The ip igmp snooping mtime command is used to specify member port
aging time for the desired port. The default aging time is 260 seconds. To
restore the default timer, please use no ip igmp snooping mtime command.
Syntax
ip igmp snooping mtime mtime
no ip igmp snooping mtime
Parameter
mtime —— Specify the aging time in seconds, ranging from 2 to 3600. The
default aging time is 260 seconds.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
253