TP-Link JetStream T3700G-52TQ - Ip Pim Join-Prune-Interval; Ip Pim Hello-Interval

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
42.10 ip pim join-prune-interval
Description
The ip pim join-prune-interval command is used to configure the interval of
join/prune packet. To restore to the default value, please use no ip pim
join-prune-interval command.
Syntax
ip pim join-prune-interval interval
no ip pim join-prune-interval
Parameter
interval —— Specify the interval of join/prune packet. It ranges from 1 to
18000 seconds. The default value is 60 seconds.
Command Mode
Interface Configuration Mode
Example
Configure the interval of join/prune packet as100s on vlan interface 2:
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# ip pim join-prune-interval 100
42.11 ip pim hello-interval
Description
The ip pim hello-interval command is used to configure the interval of Hello
packet. To restore to the default value of Hello packet interval, please use no
ip pim hello-interval command.
Syntax
ip pim hello-interval interval
no ip pim hello-interval
Parameter
interval —— Specify the interval of Hello packet. It ranges from 1 to 18725
seconds, and the default is 30 seconds.
372