JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 3 Stack
The stack technology is to connect multiple stackable devices through their stack ports,
forming a stack which works as a unified system and presents as a single entity to the network
in Layer 2 and Layer 3 protocols. This chapter describes how to manage the T3700G-52TQ
switch stacks.
3.1 boot auto-copy-sw
Description
The boot auto-copy-sw command is used to enable stack firmware
synchronization. To disable stack firmware synchronization, please use no
boot auto-copy-sw command.
Syntax
boot auto-copy-sw
no boot auto-copy-sw
Command Mode
Global Configuration Mode
Example
Enable stack firmware synchronization:
T3700G-52TQ(config)# boot auto-copy-sw
3.2 boot auto-copy-sw allow-downgrade
Description
The boot auto-copy-sw allow-downgrade command is used to enable
downgrade of image on stack member. To disable downgrade of image on
stack member, please use no boot auto-copy-sw allow-downgrade
command.
Syntax
boot auto-copy-sw allow-downgrade
no boot auto-copy-sw allow-downgrade
22
To Next Page
Loading...
