TP-Link JetStream T3700G-52TQ - Chapter 47 SDM Template Commands; Sdm Prefer

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 47 SDM Template Commands
This chapter describes how to configure the Switch Database Management (SDM) templates to
allocate hardware resources on the switch for different uses.
47.1 sdm prefer
Description
The sdm prefer command is used to configure the SDM template. The SDM
template is used to allocate system resources to best support the features
being used in your application. The template change will takes effect after a
reboot.
Syntax
sdm prefer { dual-ipv4-and-ipv6 default | ipv4-routing default | ipv4-routing
data-center default }
Parameter
dual-ipv4-and-ipv6 default —— Specify the SDM template used in the switch
as “dual-ipv4-and-ipv6”.
ipv4-routing default —— Specify the SDM template used in the switch as
“ipv4-routing default”.
ipv4-routing data-center default —— Specify the SDM template used in the
switch as “ipv4 data center”.
Command Mode
Global Configuration Mode
Example
Specify the SDM template as “dual-ipv4-and-ipv6”:
T3700G-52TQ(config)# sdm prefer dual-ipv4-and-ipv6 default
431