TP-Link JetStream T3700G-52TQ - Ip Ospf Hello-Interval; Ip Ospf Dead-Interval

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
46.27 ip ospf hello-interval
Description
The ip ospf hello-interval is used to configure the hello intervals on the
specified interface. To restore to the default value, please use the no ip ospf
hello-interval command.
Syntax
ip ospf hello-interval interval
no ip ospf hello-interval
Parameter
Interval —— The interval of the hello packets, ranging from 1 to 65535
seconds and the default value is 10 seconds.
Command Mode
Interface Configuration Mode
Example
Configure the interval of the hello packets sent on interface VLAN 2 as 20
seconds:
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# ip ospf hello-interval 20
46.28 ip ospf dead-interval
Description
The ip ospf dead-interval command is used to set the number of seconds
after the last device hello packet was seen before its neighbors declare the
OSPF router to be down. To restore to default value, please use the no ip
ospf dead-interval command.
Syntax
ip ospf dead-interval interval
no ip ospf dead-interval
419