JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
unitid
—— Specify the unit in the stack to reboot. If not specified, reboot all
members in the stack.
Command Mode
Privileged EXEC Mode
Example
Reboot all members in the stack:
T3700G-52TQ#reboot
22.13 boot application
Description
The boot application command is used to configure the image file as startup
image or backup image.
Syntax
boot application filename { image1 | image 2 } { startup | backup } [
unitid
]
no boot application
Parameter
image1 | image2 —— Specify the image file to be configured. By default, the
image1.bin is the startup image and the image2.bin is the backup image.
startup | backup —— Specify the property of the image, either startup image
or backup image.
unitid
—— Specify the unit in the stack whose image file would be configured.
If not specified, image files of all the members in the stack will be configured.
Command Mode
Global Configuration Mode
Example
Configure the image2.bin as the startup image in all the switches in the stack:
T3700G-52TQ(config)# boot application filename image2 startup
147
To Next Page
Loading...
