JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Global Configuration Mode
Example
Specify the unit 1’s role as master in the stack:
T3700G-52TQ(config)# switch 1 master
3.5 switch standby
Description
The switch standby command is used to set the role of a specified switch in
the stack as standby member. To cancel standby member setting, please use
no switch standby command.
Syntax
swtich
unitid
standby
no switch standby
Parameter
unitid
—— Specify the member number.
Command Mode
Global Configuration Mode
Example
Specify the unit 1’s role as standby member in the stack:
T3700G-52TQ(config)# switch 1 standby
3.6 switch priority
Description
The switch priority command is specify the stack member number and the
new priority for the stack member. To restore the priority of the specified
stack member to the default setting as unassigned, please use no switch
priority command.
24
To Next Page
Loading...
