TP-Link JetStream T3700G-52TQ - Ip Igmp Query-Interval

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
interface. To restore to the default value on this interface, please use no ip
igmp last-member-query-interval command.
Syntax
ip igmp last-member-query-interval interval
no ip igmp last-member-query-interval
Parameter
interval —— Specify the interval of Specific Query Messages that the switch
sends, ranging from 0 to 255 seconds. The default value is 10 seconds.
Command Mode
Interface Configuration Mode
Example
Configure the interval of Specific Query Messages that the switch sends as
20 seconds on Interface VLAN 2:
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# ip igmp last-member-query-interval 20
41.7 ip igmp query-interval
Description
The ip igmp query-interval command is used to configure the interval of
General Query Messages that the switch sends on specified interface. To
restore to the default value on this interface, please use no ip igmp
query-interval command.
Syntax
ip igmp query-interval interval
no ip igmp query-interval
Parameter
interval —— Specify the interval of General Query Messages that the switch
sends, ranging from 1 to 3600 seconds. The default value is 125 seconds.
Command Mode
Interface Configuration Mode
355