JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 36 LLDP Commands
LLDP function enables network devices to advertise their own device information periodically
to neighbors on the same LAN. The information of the LLDP devices in the LAN can be stored
by its neighbor in a standard MIB, so it is possible for the information to be accessed by a
Network Management System (NMS) using SNMP.
36.1 lldp hold-multiplier
Description
The lldp hold-multiplier command is used to configure the Hold Multiplier
parameter. The aging time of the local information in the neighbor device is
determined by the actual TTL value used in the sending LLDPDU. TTL = Hold
Multiplier * Transmit Interval. To return to the default configuration, please
use no lldp hold-multiplier command.
Syntax
lldp hold-multiplier
multiplier
no lldp hold-multiplier
Parameter
multiplier
āā Configure the Hold Multiplier parameter. It ranges from 2 to 10.
By default, it is 4.
Command Mode
Global Configuration Mode
Example
Specify Hold Multiplier as 5:
T3700G-52TQ(config)#lldp hold-multiplier 5
36.2 lldp timer
Description
The lldp timer command is used to configure the parameters about
transmission. To return to the default configuration, please use no lldp timer
command.
311
To Next Page
Loading...
