TP-Link JetStream T3700G-52TQ - Simple

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Policy-Class-Map Configuration Mode
Example
Enter the Policy-Map Config mode for a policy named tp, then add a class
named market to the policy and enter Policy-Class-Map Configuration Mode.
Redirect copies of matching packets to LAG 3:
T3700G-52TQ(config)#policy-map tp
T3700G-52TQ(config-pmap)#class market
T3700G-52TQ(config-pmap-c)#redirect lag 3
25.36 simple
Description
The simple command is used to configure simple traffic policing action. The
priority queue uses a token bucket that measures the offered load and
ensures that the traffic stream conforms to the configured rate.
Syntax
simple CIR CBS conform { drop | set-cos-as-sec-cos | set-cos-transmit |
set-dscp-transmit | set-prec-transmit | transmit } [
cos | dscp | prec ] violate
{ drop | set-cos-as-sec-cos | set-cos-transmit | set-dscp-transmit |
set-prec-transmit | transmit } [
cos | dscp | prec ]
Parameter
CIR —— Specify the token’s generation rate in Kbps. It ranges from 1 to
1000000.
CBS —— Specify the maximum capacity of the token bucket in Kbytes. It
ranges from 1 to 128.
drop
—— Drop the conforming traffic.
set-cos-as-sec-cos —— Set Cos value as secondary Cos value for
conforming traffic.
set-cos-transmit
—— Enter Cos marking action for conforming traffic.
set-dscp-transmit
—— Enter IP DSCP marking action for conforming traffic.
set-prec-transmit
—— Enter IP precedence marking action on conforming
traffic.
transmit
—— Transmit the conforming traffic.
203