TP-Link JetStream T3700G-52TQ - Ipv6 Address Dhcp; Ipv6 Address Ra

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
50.4 ipv6 address dhcp
Description
The ipv6 address dhcp command is used to enable the DHCPv6 Client
function. When this function is enabled, the Layer 3 interface will try to obtain
IP from DHCPv6 server. To delete the allocated IP from DHCPv6 server and
disable the DHCPv6 Client function, please use no ipv6 address dhcp
command.
Syntax
ipv6 address dhcp
no ipv6 address dhcp
Configuration Mode
Interface Configuration Mode
Example
Enable the DHCP Client function on VLAN interface 1:
T3700G-52TQ(config)# interface vlan 1
T3700G-52TQ(config-if)# ipv6 address dhcp
50.5 ipv6 address ra
Description
This command is used to configure the interface’s global IPv6 address
according to the address prefix and other configuration parameters from its
received RA(Router Advertisement) message. To disable this function, please
use no ipv6 address ra command.
Syntax
ipv6 address ra
no ipv6 address ra
Configuration Mode
Interface Configuration Mode
455