TP-Link JetStream T3700G-52TQ - Auto-Cost

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
cost ——The default cost of the default route, ranging form 1 to 16777214. Its
default value is 1.
type —— The type of the external routes, either 1 or 2. The default value is 2.
Command Mode
Router Configuration Mode
Example
Configure OSPF to advertise the default route whether there is default route
is the IP routing table or not:
T3700G-52TQ(config)# router ospf 1
T3700G-52TQ(config-router)# default-information originate always
46.8 auto-cost
Description
The auto-cost command is used to enable the auto computing function of
the interface cost and configure the reference bandwidth. The interface cost
is the ratio of the reference bandwidth to the interface bandwidth. To restore
the reference bandwidth to default value, please use the no auto-cost
reference-bandwidth command. To disable the auto computing function of
the interface cost, please use the no auto-cost command without
parameters.
Syntax
reference-bandwidth bandwidth
no reference-bandwidth bandwidth
Parameter
bandwidth —— The reference bandwidth, ranging from 1 to 4294967 Mbps.
Its default value is 100Mbps.
Command Mode
Router Configuration Mode
404