TP-Link JetStream T3700G-52TQ - Ip Igmp Last-Member-Query-Count; Ip Igmp Last-Member-Query-Interval

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Interface Configuration Mode
Example
Configure the IGMP version as version 2 on Interface VLAN 2:
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# ip igmp version 2
41.5 ip igmp last-member-query-count
Description
The ip igmp last-member-query-count command is used to configure the
number of Specific Query Messages that the switch sends on specified
interface. To restore to the default value on this interface, please use no ip
igmp last-member- query-count command.
Syntax
ip igmp last-member-query-count count
no ip igmp last-member-query-count
Parameter
count —— Specify the number of Specific Query Messages that the switch
sends, ranging from 1 to 20. The default value is 2.
Command Mode
Interface Configuration Mode
Example
Configure the number of Specific Query Messages that the switch sends as 3
on Interface VLAN 2:
T3700G-52TQ(config)# interface vlan 2
T3700G-52TQ(config-if)# ip igmp last-member-query-count 3
41.6 ip igmp last-member-query-interval
Description
The ip igmp last-member-query-interval command is used to configure the
interval of Specific Query Messages that the switch sends on specified
354