TP-Link JetStream T3700G-52TQ - Lldp Tlv-Select

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the SNMP notification for Gigabit Ethernet port 1/0/1:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/1
T3700G-52TQ(config-if)#lldp snmp-trap
36.6 lldp tlv-select
Description
The lldp tlv-select command is used to configure TLVs to be included in
outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command.
By default, All TLVs are included in outgoing LLDPDU.
Syntax
lldp tlv-select { [ port-description ] [ system-capability ] [ system-description ]
[ system-name ] [ management-address ] [ port-vlan ] [ protocol-vlan ]
[ vlan-name ] [ link-aggregation ] [ max-frame-size ] [ all ] }
no lldp tlv-select { [ port-description ] [ system-capability ]
[ system-description ] [ system-name ] [ management-address ] [ port-vlan ]
[ protocol-vlan ] [ vlan-name ] [ link-aggregation ] [ max-frame-size ] [ all ] }
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Exclude “management-address” and “port-vlan-id” TLVs in LLDPDU outgoing
from Gigabit Ethernet port 1/0/1:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/1
T3700G-52TQ(config-if)# no lldp tlv-select management-address port-vlan
314