TP-Link JetStream T3700G-52TQ - Dot1 X Timeout Tx-Period

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface ten-gigabitEthernet / interface range
ten-gigabitEthernet)
Example
Configure the supplicant timeout value as 5 seconds for Gigabit Ethernet port
1/0/1:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/1
T3700G-52TQ(config-if)#dot1x timeout supplicant-timeout 5
17.4 dot1x timeout tx-period
Description
The dot1x timeout tx-period command is used to configure the transmit
period on the specified port. To restore to the default, please use no dot1x
timeout tx-period command.
Syntax
dot1x timeout tx-period time
no dot1x timeout tx-period
Parameter
time —— The transmit period which determines when an
EAP-Request/Identity packet is to be transmitted, ranging from 1 to 65535 in
second. By default, it is 30 seconds.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface ten-gigabitEthernet / interface range
ten-gigabitEthernet)
Example
Configure the transmit period value as 10 seconds for Gigabit Ethernet port
1/0/1:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/1
T3700G-52TQ(config-if)#dot1x timeout tx-period 10
98