JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
auto | authorized-force | unauthorized-force —— The Control Mode for the
port.
auto:
In this mode, the port will normally work only after passing the 802.1X
Authentication.
authorized-force: In this mode, the port can work normally without passing
the 802.1X Authentication.
unauthorized-force: In this mode, the port is forbidden working for its fixed
unauthorized status.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface ten-gigabitEthernet / interface range
ten-gigabitEthernet)
Example
Configure the Control Mode for Gigabit Ethernet port 1/0/20 as
“authorized-force”:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/20
T3700G-52TQ(config-if)#dot1x port-control authorized-force
17.10 dot1x port-method
Description
The dot1x port-method command is used to configure the control type of
IEEE 802.1X for the specified port. By default, the control type is “mac-based”.
To restore to the default configuration, please use no dot1x port-method
command.
Syntax
dot1x port-method { mac-based | port-based }
no dot1x port-method
Parameter
mac-based | port-based ——The control type for the port.
102
To Next Page
Loading...
