JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
two-rate
CIR CBS PIR PBS
conform { drop
|
set-cos-as-sec-cos
|
set-cos-transmit | set-dscp-transmit | set-prec-transmit | transmit }
[
cos
|
dscp
|
prec
] exceed { drop
|
set-cos-as-sec-cos
| set-cos-transmit |
set-dscp-transmit | set-prec-transmit | transmit
} [
cos
|
dscp
|
prec
] violate
{ drop
|
set-cos-as-sec-cos
| set-cos-transmit | set-dscp-transmit |
set-prec-transmit | transmit }
[
cos
|
dscp
|
prec
]
Parameter
CIR ——
Specify the token’s generation rate in Kbps for token bucket C. It
ranges from 1 to 1000000.
CBS ——
Specify the maximum capacity in Kbytes for token bucket C. It
ranges from 1 to 128.
PIR ——
Specify the token’s generation rate in Kbps for token bucket P. It
ranges from 1 to 1000000.
PBS ——
Specify the maximum capacity in Kbytes for token bucket P. It
ranges from 1 to 128.
drop
——
Drop the conforming traffic.
set-cos-as-sec-cos ——
Set Cos value as secondary Cos value for
conforming traffic.
set-cos-transmit
——
Enter Cos marking action for conforming traffic.
set-dscp-transmit —— Enter IP DSCP marking action for conforming traffic.
set-prec-transmit —— Enter IP precedence marking action on conforming
traffic.
transmit —— Transmit the conforming traffic.
cos
—— The Class of Service(Cos) value in an Ethernet frame header, ranging
from 0 to 7.
dscp
—— Enter a DSCP value in the range of 0 to 63.
prec
—— Enter an IP precedence value in the range of 0 to 7.
Command Mode
Policy-Class-Map Configuration Mode
Example
Enter the Policy-Map Config mode for a policy named tp, then add a class
named market to the policy and enter Policy-Class-Map Configuration Mode.
For token bucket C, set the token’s generation rate as 1000 Kbps and the
maximum capacity as 64 Kbytes. For token bucket P, set the token’s
206
To Next Page
Loading...
