TP-Link JetStream T3700G-52TQ - Page 250

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
source-ip —— The source IP address contained in the rule.
source-ip-mask —— The source IP address mask. It is required if you typed
the source IP address.
destination-ip —— The destination IP address contained in the rule.
destination-ip-mask —— The destination IP address mask. It is required if you
typed the destination IP address.
time-segment —— The time-range for the rule to take effect. By default, it is
not limited.
dscp —— Specify the dscp value, ranging from 0 to 63.
s-port —— The source port number.
d-port —— The destination port number.
tcpflag —— Specify the flag value when using TCP protocol.
protocol —— Configure the value of the matching protocol.
tos —— Enter the IP ToS contained in the rule.
pre —— Enter the IP Precedence contained in the rule.
enable —— The corresponding rule will take effect on the fragment packets.
All the fragments and the last piece of fragment will be always forwarded.
disable —— The corresponding rule will not take effect on the fragment
packets.
rate-limit —— The rate of Stream Condition, ranging from 1 to
10000000kbps.
value —— The COS queue ID, ranging from 1 to 6.
icmptype —— The predefined ICMP type.
icmpcode
—— The predefined ICMP code.
mirror-port —— The Mirror Port number of Stream Mirror.
redirect-port —— The Destination Port of Redirect. The data packets
matching the corresponding ACL will be forwarded to the specific port. By
default, it is All Ports.
Command Mode
Global Configuration Mode
Example
Create an Extended-IP ACL whose ID is 110, and add Rule 10 for it. In the rule,
the source IP address is 192.168.0.100, the source IP address mask is
227