JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
cpu-threshold —— Enable SNMP cpu threshold traps. It is sent when CPU
usage exceeds the predefined threshold. By default, the CPU usage threshold
of the switch is 80%.
fan —— Enable SNMP fan traps.
inventory —— Enable card/stack/SFS traps.
link-mode —— Enable SNMP Link up/down traps.
mac-lock-violation —— Enable SNMP mac-lock-violation traps. It is sent
when a packet with a disallowed MAC address is received on a locked port.
memory-threshold —— Enable SNMP memory traps. It is sent when CPU
usage exceeds 80%.
multi-users —— Enable SNMP multi users traps. It is sent when the same user
ID is logged into the switch more than once at the same time.
pim —— Enable SNMP pim traps.
power —— Enable SNMP power traps.
spanning-tree —— Enable SNMP MSTP traps. It is sent when the status of
STP changes.
storm-control ——Enable storm-control traps. It is sent when the multicast or
broadcast rate exceeds the predefined value.
temperature —— Enable SNMP temperature traps.
vlan —— Enable SNMP VLAN traps. It is sent when a VLAN is created or
deleted.
vrrp —— Enable SNMP VRRP traps.
Command Mode
Global Configuration Mode
Example
Enable SNMP extended vrrp traps for the switch:
T3700G-52TQ(config)# snmp-server traps vrrp
297
To Next Page
Loading...
