Trimble FM-1000 - Basic correction settings

GPS receiver settings 5 Connectivity settings
Basic correction settings
For the basic corrections, complete the following steps.
1.
At the Configuration screen, tap GPS Receiver, then tap Setup. The GPSReceiver Settings
screen displays.
2.
On the Settings tab, from the Corrections list select either:
ll Autonomous
l SBAS
3.
On the Advanced tab, enter the settings.
Setting Explanation
Elevation Mask
SNR Mask
RTKBase Station Filter Enabled, Disabled
RTKBase Station CMRID Can be edited if Filter is enabled
Scintillation Filter On or Off
4.
On the Logging tab, if you want to record logs, select Record Logs.
5.
On the Radar Output tab, enter the settings.
Setting Explanation
Connector
None or ConnectorD
Radar Frequency Rate Enter Hz/mph rate
6. When you have completed the settings, tap OK.
110 FM-1000 Integrated Display User Guide Version 9.25, Revision B