Trimble FM-1000 - OmniSTAR HP;XP;G2 - VBS

GPS receiver settings 5 Connectivity settings
OmniSTAR HP/XP/G2 - VBS
OmniSTARVBS is a satellite-based subscription correction service delivered either by:
l Satellite
l Internet using a DCM-300 modem with <1.5" (3.8 cm) accuracy and GLONASS compatibility
Note – Make sure you have unlocked the service before setting it up.
1.
At the Configuration screen, tap GPS Receiver, then tap Setup. The GPSReceiver Settings
screen displays.
2.
On the Settings tab, complete the settings.
Setting Explanation
Antenna Selection Select a supported antenna type
Corrections
Choose OmniSTARHP/XP/G2 - VBS
FastRestart
On or off
FastRestart technology greatly reduces the time needed for
convergence. After the satellite signal has initially
converged, you can turn off the receiver. When you turn
the receiver on again, accuracy levels will be similar to those
experienced before shutdown.
Note –
Do not move the vehicle from the point of system shut
down. Otherwise this feature will not work.
Convergence Threshold
Disabled
GPSOutput Tap to open the GPSOutput Settings screen to send
messages. See
GPSoutput settings (page 125)
.
3.
On the Advanced tab, only alter the settings if directed by Support.
Setting Explanation
Elevation Mask
SNRMask
4. On the Logging tab, if you want to record logs, select Record Logs.
118 FM-1000 Integrated Display User Guide Version 9.25, Revision B