TrueGuide operation 18 Operations
TrueGuide operation
WARNING – Many large and sudden changes in satellite geometry caused by blocked satellites can cause
significant position shifts. If operating under these conditions, auto-guidance systems can react abruptly. To avoid
possible personal injury or damage to property under these conditions, disable the auto-guidance system and take
manual control of the vehicle until conditions have cleared.
TrueGuide uses a second GPSreceiver on the implement to enable the Autopilot system to pull the
implement onto the guidance line.
To open the TrueGuide panel, at the Run screen, tap .
Control Explanation
Trim
Aggr
Adjust aggressiveness during operation.
Use the - and + buttons to adjust how aggressively the
implement moves to the guidance line.
l To increase the response to move the implement back to
the line, increase aggressiveness.
l To smooth the response to the implement moving offline,
decrease aggressiveness
The recommended settings for default values are:
l For steep slopes (10% - 30%): 150%
l For slow speed applications: 125%
l For normal operation: 100%
l For high speed applications (>8 mph): 33%
TrueGuide engagement
On: When the right-hand button displays ON, the Autopilot
system is engaged.
Auto: When the right-hand button displays AUTO, the
TrueGuide system is engaged.
Off: Tap to disengage the TrueGuide system.
426 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...