Edit implement settings 7 Implement setup
1. Navigate to the Implement Setup screen.
2. On the Implement Type tab:
a. From the Operations list, choose the operation.
b. Tap Edit. The Select Implement Layout screen displays.
c.
Tap the appropriate layout and then tap OK.
Operations Layouts
Spreading
Pull-type spreader
Self-propelled spreader
Spraying
Self-propelled, front boom
Self-propelled, rear boom
Pull-type sprayer
Planting
Standard
Front split
Rear split
Center offset
Seeder None
Tillage None
Other None
Measurements
The measurements you enter affect the accuracy of your position in relation to GPS and steering,
whether automatic or manual. In this tab, you will enter this information:
l The width of your implement, vehicle or header: The swath width.
l The width of the tool or boom:The application width recorded by coverage logging.
Note – The screen is scaled to the swath or application width, whichever is larger. If any offset is greater than
this, the tractor image may pass the edge of the screen.
Measurement Explanation
Swath Width
How wide you want the swath to be. If you want to overlap
coverage, measure the application width and add the
appropriate amount for overlap.
Application Width
The application width of the tool or boom.
Affects the width of the coverage logging and mapping.
156 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...