Trimble FM-1000 - CenterPoint RTX (fs)

5 Connectivity settings GPS receiver settings
CenterPoint RTX (fs)
CenterPoint RTX™(fs - fast satellite) is a satellite-based subscription correction service for the United
States that also requires RTK(advanced) to be unlocked.
Note – Make sure you have unlocked the service before setting it up.
1.
At the Configuration screen, tap GPS Receiver, then tap Setup. The GPSReceiver Settings
screen displays.
2.
On the Settings tab, complete the settings.
Setting Explanation
Antenna Selection Select a supported antenna type
Corrections
Choose CenterPointRTX(fs)
GPSOutput Tap to open the GPSOutput Settings screen to send
messages. See
GPSoutput settings (page 125)
.
3. On the Frequencies tab, enter the settings for Frequency and Baud Rate. See Frequencies and baud
rate (page 124).
4.
On the Advanced tab, only alter the settings if directed by Support.
Setting Explanation
Elevation Mask
SNR Mask
RTKBase Station Filter Enabled, Disabled
RTKBase Station CMRID Can be edited if Filter is enabled
Scintillation Filter On or Off
5.
On the Logging tab, enter the settings.
Setting Explanation
Record AgRemote Logs Off or Record Logs
Version 9.25, Revision B FM-1000 Integrated Display User Guide 113