GPS receiver settings 5 Connectivity settings
SecureRTK is a Trimble proprietary base station security feature that enables a service provider
with a RTK base station to generate time-based access codes for their supported rovers. If
SecureRTK is enabled on the base station, rovers with authorized access codes can use
corrections from that base.
SecureRTK requires firmware version 1.59, or later, on MS750
™
GPS receivers, and firmware
version 4.60 or later on AgRTK, AgGPS 442, and Ag GPS 542 base stations.
Note – Rovers without a SecureRTK access code are unable to access a secure Trimble RTK base station.
5.
On the Advanced tab, only alter the settings if directed by Support.
Setting Explanation
Elevation Mask
SNR Mask
RTKBase Station Filter Enabled, Disabled
RTKBase Station CMRID Can be edited if Filter is enabled
Scintillation Filter On or Off
6.
On the Logging tab, if you want to record logs, select Record Logs.
7.
On the Radar Output tab, enter the settings.
Setting Explanation
Connector
Select Connector D to enable radar output.
The display can convert GPS speed into an analog
frequency that is identical to output from a radar speed
sensor.
Radar Frequency Rate Enter the required rate.
8. When you have completed the settings, tap OK.
112 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...