Crop settings 17 Yield Monitoring setup
Setting Explanation
Note –
Not available for
the Claas 600/700. This
is set by the CEBIS.
Logging Height is read from the Header Height Sensor.
If required, tap Current Height to enter values related to your own setup.
Grain Flow Delay Time (in seconds) it takes for the grain to reach the yield sensor after it
enters the head
Reset Autocut Controls when the rows are automatically reset
l When head is lifted: Automatically resets the rows at the end of the
row when the head is raised above the logging height
l Never:Disables autocut. Rows must be controlled manually.
Crop Overlap
When more than one crop variety is detected in the head, the system
will stop accumulating variety statistics. Use this setting to adjust the
percentage of crop overlap that is allowed before the system stops
accumulating variety statistics.
Select a value between 1% and 25%. For best results, the recommended
setting is 10%.
Crop settings
At the Yield Monitoring Setup screen on the Crop tab, enter the settings for your crop.
Setting Explanation
Commodity Select the crop that is currently being harvested
Units Select the unit of measure for the crop type:
l Bushels/acre
l Lbs/acre
l Tons/acre
l Hundred Weight/acre (When this is selected, the Bushel
Weight field is automatically set to 100 lbs.)
l Bushels/hectare
l Kgs/hectare
l Tonnes/hectare
Standard Bushel Weight Enter the weight of a single bushel of crop.
Storage Moisture Set the cutoff point between a wet crop and a dry crop. Set
330 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...