18 Operations Guidance pattern use
Setting Tap to...
Left Shift the line to the left of your view.
Right Shift the line to the right of your view.
Value entry boxes Enter the distance you want to shift the line.
Metric Change to metric values.
Feet &Inches Change to feet and inches.
Decimal Feet Change to decimal feet.
Rows
Calculator Open the calculator.
Note – If you shift a line, it will shift the original version of the line and remove any skip that you have
applied.
6. Tap OK. The Swath Management screen displays. The newly shifted swath displays in the
swath list on the left of the screen.
Skip a swath
Note – The Skip position of a swath line is temporary and is not saved permanently. To save such an
adjustment, shift the swath instead. See Shift a swath (page 378).
FM-1000 integrated display uses the original swath that you drove to automatically generate the
position of the other swaths. Occasionally, the on-screen swaths do not accurately indicate where
your swaths are. For example, you may need to skip a swath to drive to the other side of a road.
To temporarily correct the spacing of the automatically generated swaths in a field:
1.
At the Run screen, tap to open the Mapping Guidance panel.
2. Tap Skip. The Enter the Skip Distance screen displays.
3.
Complete the settings.
Setting Tap to...
Left Shift the line to the left of your view.
Right Shift the line to the right of your view.
Value entry boxes Enter the distance you want to skip to the next swath.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 379
To Next Page
Loading...