Water Management functionality 18 Operations
Setting Explanation
indicates the cut areas. Blue indicates the fill areas. Green
indicates areas that do not need cut or fill.
3.
Tap Best Fit.
The system uses the interior points that you collected to calculate the optimum slope of the
field. An arrow displays on the image of the field to show the direction of fall. The Stats table lists
the statistics of the design computation:
ll Cut: The volume of material that must be removed for the current design.
l Fill:The volume of material that must be added for the current design.
l Area:The area of the field inside the boundary.
4.
Tap OKto close the AutoPlane screen and save the design. The the system saves the design as
the default plane for this field.
Leveling
Before you begin your leveling operation using Field LevelII, you may need to:
l Import designs (page 444)
l Reload a field (page 444)
l Re-bench (page 444)
Getting started with leveling
The FieldLevel II system automatically raises and lowers the blade on the implement to match the
design height anywhere in the field. You will use the color cut/fill map, simple on-screen
adjustments, and automatic blade control to perform leveling.
In addition to the following instructions, depending on where you are in your operation, you may
need to:
l Reload a field (page 444)
l Re-bench (page 444)
1. Open a field as normal.
2.
When your leveling model is set to Multiplane design and the FM-1000 integrated display
opens the field, the system:
ll Scans the \AgGPS\Designs\.
l Opens any Multiplane .gps control files that are close to your current position and displays
a list of these files in the Select Design screen.
3. Select the design you want to use and tap OK.
436 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...