Trimble FM-1000 - Tandem; dual calibration

Tandem / dual scraper setup 16 Water Management setup
Tandem / dual calibration
When working with a tandem/dual configuration, the valve module must be calibrated for both:
l FieldLevel II: Relates to the front implement cylinder in a tandem configuration, or the left side
cylinder of a single implement.
l Tandem/Dual:Relates to the rear implement cylinder in a tandem configuration, or the right
side cylinder of a single implement.
Depending on the make and manufacturer of your vehicle, the tractor computer may need to be
put into a special mode. Please refer to the FieldLevel II Installation Guide for your vehicle type.
1.
At the Configuration screen, select Tandem/Dual and then tap Calibrate.
2. Set the vehicle throttle to 100%.
3.
Tap Start.
The system performs its calibration sequence to test the speed at which the blade raises and
lowers. This process takes approximately 8 – 10 minutes.
4. To manually calibrate the valve, enter values in the three Manual Calibration entry boxes and then
tap OK.
310 FM-1000 Integrated Display User Guide Version 9.25, Revision B