16 Water Management setup WM-Drain setup
Setting Explanation
each time you increase or decrease the slope on the Install tab
when in Point and Slope mode.
For example, if the leveling gradient is 3% and the Slope Adjust
value is set to 2%, the leveling gradient changes to 5% if you
decrease the slope.
Relative heights settings
Select the Relative Heights tab and complete the settings.
Setting Explanation
Relative Heights
Enabled:Select to use the relative heights from the master
benchmark.
Disabled:Select to use GPS heights at all times.
Relative X If relative heights are enabled, this is the X coordinate that will
be applied to the master benchmark.
Relative Y If relative heights are enabled, this is the Y coordinate that will
be applied to the master benchmark.
Height Offset If relative heights are enabled, this is theheight value that will
be applied to the master benchmark.
Operation settings
Select the Operation tab and enter the settings.
Setting Explanation
Force Rebench
Yes:If the field has been closed and then reopened, the
system will not allow you to begin work until you have re-
benched. Use this setting if you are using a different base
station setup between work sessions.
No: Select if you have a permanent base station setup that is
never moved.
VDOP Level Vertical Dilution of Precision measurs the vertical accuracy of
the GPS signal. If the VDOP reaches the value you enter, a
warning will display. A setting of less than 3 is recommended.
As-Built Logging
Manual:Logs data if hydraulics are engaged and if you have
begun logging in the Run screen.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 315
To Next Page
Loading...