Trimble FM-1000 - Shift or skip guidance line

18 Operations Row Guidance operation
Shift or skip guidance line
You may need to skip the guidance line to coordinate with the crop and guidance line if you operate
in a crop that was planted:
l Without automatic steering
l Using WAAS corrections and is being harvested using WAAS guidance
In either case, satellite drift and/or operator guidance can lead to misalignment of the guidance line
with the crop. Depending on conditions, it may be necessary to shift or skip the guidance line to
coordinate with the crop and guidance line. This will be evident when the sensors guide down the
proper row with offline distance is shown to be 0, but the selected guidance line is not centered on
the current swath on the screen.
In this case it is recommended to skip (temporarily move the guidance line) to align with the drifted
crop rows. The Autopilot system must be disengaged to skip.
See Shift a swath (page 378) and Skip a swath (page 379).
Version 9.25, Revision B FM-1000 Integrated Display User Guide 421