Trimble FM-1000 - Claas Cebis Auto Pilot calibration; Greenstar Monitor: Stop Head Height setup

Third-party display instructions 17 Yield Monitoring setup
Claas Cebis Auto Pilot calibration
Activate the AutoPilot system
1.
Tap and then tap .
2.
Tap and then scroll to On.
Steering angle and steering system setup
1.
Tap and then tap .
2.
Tap and then tap .
3. Tap Learning sensing system.
Centralizing switch setup
1.
Tap and then tap .
2.
Tap , scroll left or right to adjust the central position and then select OK.
Steering sensitivity setup
1.
Tap and then tap .
2.
Tap , scroll left or right to adjust the steering sensitivity and then select OK.
Greenstar Monitor:Stop Head Height setup
1. Tap .
2.
Tap for Harvest Monitor.
3. Position the header to 100%.
4.
Tap next to Record Stop Height.
Stop Head Height on the Command Center
1. Navigate to Home screen on the Command Center.
2.
Tap the Combine icon in the lower right corner of the screen.
3. Tap the third button from the left on the command center to select the Combine tab.
338 FM-1000 Integrated Display User Guide Version 9.25, Revision B