Trimble FM-1000 - Valve settings; Limit and increment settings

WM-Drain setup 16 Water Management setup
Setting Explanation
Lateral Offset of the antenna from the center line of the pipe.
Boot Length Distance from where the pipe exits, to the back of the boot, to the
leading edge of the boot.
Offset The distance of the GNSSantenna from the approximate center of
vehicle rotation (the fixed rear axle of a towed plow or the center of
the tracks). Forward is the antenna in front of the pivot
point.Backward is the antenna behind the pivot point.
Antenna Selection Select the antenna from the list.
Valve settings
Select the Valve Setup tab and complete the settings for the PWMvalve.
Setting Explanation
Valve Module Displays the type of valve module that is detected.
Valve Type Select the type of valve that is connected.
Valve Inverted
Leave this value as Not Inverted unless the raise and lower hoses
have been installed incorrectly on the valve.
If this is the case, select Inverted to eliminate the need to reverse
the hoses.
Limit and increment settings
Select the Steps tab and complete the settings.
Setting Explanation
Height Step
Fine:You can change height steps in small increments.
Coarse:You can change height steps in large increments.
Pitch Step
Fine:You can change height steps in small increments.
Coarse:You can change height steps in large increments.
On-grade Limit This limit sets the distance the blade can move before the
green blade height indicators change to a thin red arrow. At
twice this distance, the height indicators become think red
arrows. See blade position in
Blade level indicators (page 446)
.
Slope Adjust
This percentage controls the amount the gradient changes
314 FM-1000 Integrated Display User Guide Version 9.25, Revision B