Control setup 9 Field-IQ system setup
Control setup
The first time you tap Control Setup, the Control Setup screen is blank and you can only add a
location.
After you have added a location, you can select it from the Location list on the right-hand side of the
screen to see the assigned modules.
Button Tap to...
Add
Add and set up a new control location. This opens the Control Details
screen, which contains the following tabs:
l Material tab (page 215)
l Layout (page 217)
l Section Control tab (page 219)
l Rate Control tab, 1
l Row monitoring (page 226)
l Sensor tab (page 227)
Edit
View or edit the details of an existing control location.
Delete
Delete an existing location.
A message displays prompting you to tap either:
l
Remove
to remove the material
l
Cancel
to return to the
Control Setup
screen
214 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...