Trimble FM-1000 - Changes to this document

Changes to this document 1 Introduction
Changes to this document
The changes for the FM-1000 integrated display firmware version 9.25 are:
l Remote Output: Crossing a Line Feature has been added. See Remote Output settings (page
131) and Remote Output operation (page 414).
l WM Drain:Changes to the Run screen and added features, including clipping/deleting a section
line and adding fixed points during design. See WM-Drain operation (page 451).
l Serial NMEA messages:10Hz has been added as an output. See Serial NMEA messages (page
126).
The changes for the user guide for FM-1000 integrated display (version 9.25, revision B) are:
l Correction to the number of PWM drives (from 4 to 6) that can be used for planters using Field-
IQ. See Field-IQ system functionality (page 208).
24 FM-1000 Integrated Display User Guide Version 9.25, Revision B