Trimble FM-1000 - CenterPoint RTK

5 Connectivity settings GPS receiver settings
CenterPoint RTK
Trimble CenterPoint™ RTK is radio-broadcast corrections from a ground-based reference station
using either:
l Single-based line (CenterPoint RTK)
l Internet with a DCM-300 modem (CenterPoint VRS)
1.
At the Configuration screen, tap GPS Receiver, then tap Setup. The GPSReceiver Settings
screen displays.
2.
On the Settings tab, complete the settings.
Setting Explanation
Antenna Selection Select a supported antenna type
Corrections
Choose CenterPointRTK
Net ID
GPSOutput Tap to open the GPSOutput Settings screen to send
messages. See
GPSoutput settings (page 125)
.
3.
On the xFill tab, enter the settings.
Setting Explanation
x-Fill™ technology
On or Off
During RTK signal interruptions, xFill technology can sustain
RTK operation for up to 20 minutes.
Frequency See
Frequencies and baud rate (page 124)
.
Baud Rate See
Frequencies and baud rate (page 124)
.
Datum Selector
Choose the datum that was used when the RTK base
station was surveyed. For more information contact your
local reseller.
Note –
You must select the correct base datum for your location.
If you select an incorrect value, this will result in incorrect xFill
operation.
4.
On the SecureRTK tab, enter the key or keys and an optional description.
The base station access code provided by your base station service provider. After you enter
this code, the Status and Expiry values change to show the current status of the security feature.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 111