FieldLevel II Leveling 16 Water Management setup
FieldLevel II Leveling
The FieldLevel II system:
l Uses a high-accuracy GPS receiver with an antenna mounted on the implement blade to
measure and control its elevation
l Defines the three-dimensional height for the field and controls how the implement reshapes
the ground
l Automatically raises and lowers the blade on the implement to match the design height
anywhere in the field
l Includes a color cut/fill map, simple on-screen adjustments, and automatic blade control
makes leveling easy
l Supports tandem or dual scraper implements
ll With a tandem system, the second scraper is also controlled by GPS. You can work in areas
requiring cuts and fill two scraper buckets before you have to empty the scrapers.
l With a dual system, an antenna on each side of the scraper controls two independent
cylinders. This creates a more accurate surface by controlling the height of both ends of
the scraper.
l Supports the EZ-Remote joystick or with custom switches controlled by a Signal Input Module
(SIM)
Requirements
The FieldLevel II system requires:
l FM-1000 integrated display, with or without the Autopilot system
l Platform kit to suit your vehicle and valve type (P/N 55045-xx)
l Unlock code for the field leveling functionality
l Leveling or drainage implement
Setup process
Note – Before you can configure the system, it must be professionally installed. For more information,
contact your local reseller.
FieldLevel II setup and calibration include:
1. Target height (page 301)
2. GPS receiver setup (page 302)
300 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...