12 Serial Rate Control setup Hardi 5500 and 6500
Rates from all channels are recorded in the variable rate logging .dbf file, but the display can send
rates to only one channel at a time: the active channel.
The Tyler Flex-Air controller uses the GPS speed sent by the display.
Operation
Statistics for the active channel are recorded in:
l The Total_Qty value in the variable rate logging .dbf file
l The Avg_Rate field in the EventHistory .dbf file
If you want to use these statistics, start a new event before you change the active channel.
Application width
You can individually configure the widths of the boom sections on the controller. The display draws
coverage logging at the width of the sum of all the boom sections. If you turn boom sections off, the
display varies the width of the coverage polygons according to which boom sections are on.
Hardi 5500 and 6500
1.
To connect the Hardi 5500 or 6500 controller, you need a special adapter cable (P/N 59043) to
connect to the cable P/N 67091. Cable P/N 6709 will be connected to Port A or B on the display .
Optionally, you can use an extension (straight through) serial cable.
a. Connect the cable to serial port 1 on the Hardi controller.
b. On the Hardi 6500, use terminal version 1.55 or later and Jobcom version 1.55 or later.
c. Set the Hardi 6500 to metric units.
2. Set up the controller:
a. Turn on the controller while holding the ESCbutton.
b. In the extended menu, use the arrow keys to select the E.4 Data Exchange menu.
c.
Enter the COM 1 setup and complete the settings.
Setting Enter...
Equipment type VRA/remote
Protocol Hardi VRA
Baud Rate 9600
3. Turn off the controller and turn it on again.
4. Go to Menu 2.3 and select VRA/Remote Control Enable.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 259
To Next Page
Loading...