Trimble FM-1000 - Yield Monitoring settings

Yield Monitoring settings 17 Yield Monitoring setup
Yield Monitoring settings
The following yield monitoring systems are supported:
l Trimble Yield Monitoring
l
Various supported OEM moisture sensors
l Claas, 670 and 700 series (North America only)
l John Deere, -60 and -70 series
l
Serial data input
Before setup
Before setting up Yield Monitoring, make sure:
1. All components are installed on the vehicle. Refer to the Installation Guide that is shipped with
every Yield Monitoring kit.
2. Yield Monitoring has been added to the display's configuration. See Activate features/plugins
for use (page 47).
3. The implement has been set up and configured for the appropriate operation. See Implement
setup (page 152).
Setup steps
To complete the setup for Yield Monitoring:
1. Choose the combine and complete its settings. See Combine settings (page 329).
2. Complete the Operation settings (page 329).
3. Enter the Crop settings (page 330) for your crop.
4. Complete settings for the map legend. See Map settings (page 331).
5. Complete the Sensor output settings (page 331).
6. Complete the Options settings (page 332).
328 FM-1000 Integrated Display User Guide Version 9.25, Revision B