Trimble FM-1000 - Line Acquisition Aggressiveness calibration

Implement calibration for TrueTracker system 14 TrueTracker setup
11. Repeat steps 5 through 10 two more times, for a total of three test runs. Average the results of
the three runs. (Total the offset distances from the three passes and divide by three). Use the
table in step 10 to record your results.
Line Acquisition Aggressiveness calibration
1. At the Implement ControllerSetup screen, select Line Acquisition and tapOK. The Autopilot Line
Acquisition screen displays.
2.
Adjust the line acquisition aggressiveness slider.
The slider controls how aggressively the implement approaches the guidance line, using a scale
from 50% to 150%. The optimal value for each profile is not necessarily 100%. It varies for
different implement profiles.
290 FM-1000 Integrated Display User Guide Version 9.25, Revision B