Trimble FM-1000 - Implement setup; Prepare connections; Primary receiver setup; Secondary receiver setup

Tandem / dual scraper setup 16 Water Management setup
Implement setup
If you have not already configured the implement, see Implement setup (page 308).
Prepare connections
If not already installed on the display, install:
l FieldLevel II
l Tandem/Dual
When installed, the Configuration screen will show:
l FieldLevel II with its associated GPS receiver
l Tandem/Dual with its associated GPS receiver
Primary receiver setup
FieldLevel II controls the primary receiver.
1.
At the Configuration screen below Field Level, select the GPS receiver listed and then tap
Setup.
2. From the Receiver list, select Internal Primary.
3. From the Corrections list, select RTK.
4. Set the Network ID field to the same network ID that is set in the base receiver.
Secondary receiver setup
Tandem/Dual controls the secondary receiver.
1.
At the Configuration screen below Tandem/Dual, select the GPS receiver listed and then tap
Setup.
2. From the Receiver list, select Internal Secondary.
Tandem / Dual settings
You must set up the FM-1000 integrated display to control either a tandem configuration or a dual
configuration, depending upon the implement being used.
At the Configuration screen, select Tandem/Dual and then tap Setup. The Tandem/Dual Setup screen
displays.
308 FM-1000 Integrated Display User Guide Version 9.25, Revision B