Trimble FM-1000 - Section Control tab; Material linking

9 Field-IQ system setup Control setup
Section Control tab
With section control, you can avoid double coverage and eliminating wasted inputs using automatic
or manual section control. Section control:
l Automatically control up to 48 rows individually
l Enables you to see where you have been and what you have done with overlap detection
l Eliminates overlap by adding Tru Count Air Clutches® and Tru Count LiquiBlock™ valves
At the Section Control tab, you can set up section control as:
l Rate as Section:To use rate control drives as section shutoffs
l Material linking: To link primary and secondary materials
l Automatic Section Control: Automatic section control with various section control devices
Rate as Section
The Field-IQ system can use the rate control drives as section shutoffs. For example, when going
into a nonproductive or covered area the rate control drives will be commanded to zero rate.
1.
To set up rate as sections, at the Section Control tab, complete these settings.
Setting Explanation
Section Control Select Rate as Section.
Section Control Tap
Setup
to adjust latency and overlap values.
2. Select the Rate Control tab and then set up rate control.
Material linking
The Field-IQ system can link primary and secondary materials, where the secondary material uses
the output of the primary material. For example, LiquiBlock valves can be linked to use the output
of Tru Count Air Clutch systems.
When planting, seeding, or strip-tilling, you can link the following together:
l Liquid
l Granular seed
l Granular fertilizer
Note – Anhydrous cannot be linked.
When the system is in diagnostics mode:
Version 9.25, Revision B FM-1000 Integrated Display User Guide 219