Trimble FM-1000 - Vaderstad Control Station

Vaderstad Control Station 12 Serial Rate Control setup
Vaderstad Control Station
1. Connect the FM-1000 integrated display to the Vaderstad Control Station:
a. Connect the special adapter cable (P/NDCA6219) with a crossover serial cable (null
modem) to the Vaderstad program cable (Vaderstad P/N 428017).
b. Plug the Vaderstad cable into the GPS port on the back of the Control Station controller.
2. Set up the controller:
a.
Press the ? button and hold it down while turning on the controller.
Note – Pressing ? and selecting Info will not work if the unit is communicating with the display.
b. In the Setup screen, scroll to GPS and then select No.
264 FM-1000 Integrated Display User Guide Version 9.25, Revision B