TrueGuide calibration 13 TrueGuide setup
TrueGuide calibration
WARNING – Many large and sudden changes in satellite geometry caused by blocked satellites can cause
significant position shifts. If operating under these conditions, auto-guidance systems can react abruptly. To avoid
possible personal injury or damage to property under these conditions, disable the auto-guidance system and take
manual control of the vehicle until conditions have cleared.
To calibrate the TrueGuide system, you must have a field open in the Run screen with an AB line
configured. See Fields (page 353) and Guidance pattern use (page 357).
At the Run screen:
1.
Tap . Without closing the field, the Configuration screen displays.
2.
Select TrueGuide and tap Calibrate. The TrueGuide Calibration screen displays.
3.
Tap Next and follow the on-screen instructions.
4.
Complete the test at least four times and tap OK.
5. At the Calibration screen, tap OK to return to the open field.
272 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...