Trimble FM-1000 - Valve module calibration

FieldLevel II Leveling 16 Water Management setup
Valve module calibration
Note – Depending on the make and manufacturer of your vehicle, the tractor computer may need to be put
into a special mode. Refer to the FieldLevel II Installation Guide for your vehicle type.
1.
At the Configuration screen, select FieldLevel II and then tap Calibrate. The FieldLevel
IICalibration screen displays.
2. Set the vehicle throttle to 100%.
3.
For automatic calibration, tap Start.
The system performs its calibration sequence to test the speed at which the blade raises and
lowers. This process takes approximately 8 – 10 minutes.
4. To manually calibrate the valve, enter values in the three Manual Calibration entry boxes and
then tap OK.
Note – Stopped DeadBand is the control deadband that is applied when the implement is traveling at less
than 0.1 mph.
306 FM-1000 Integrated Display User Guide Version 9.25, Revision B