16 Water Management setup FieldLevel II Leveling
Setting Explanation
will not let you begin work again until you have re-benched. Use this
setting if you are using a different base station setup between work
sessions.
If you have a permanent base station setup that is never moved, select
No. The system will not force you to rebench.
To view relative offset values on the Run screen, set the offsets as status text items on the slide-out
tab. See Status items (page 70).
Valve Setup tab
Setting Explanation
Valve Module Type of valve module that is detected
Valve Type Select the type of valve that is connected.
Valve Inverted
Not Inverted:(Default)Keep this setting unless the tank and pressure hoses
have been installed incorrectly on the valve.
Inverted:Select if tank and pressure hoses have not been installed
correctly. This eliminates the need to reverse the hoses.
Height Filter Tab
Choose the filter for height:
Setting Explanation
None This setting (this is the raw GPS data used for height) is recommended.
Average The height will be averaged using the number of positions selected. This
will smooth spikes in height readings but will introduce a latency into the
controls.
Jump Detect
This will filter out some jumps in the height readings. When selected, the
following values must be entered:
l Threshold:The change in height value that will trigger the filter
l Decay Time:After the filter is triggered, the amount of time it takes
to gradually resume using the raw GPS height
Version 9.25, Revision B FM-1000 Integrated Display User Guide 305
To Next Page
Loading...